Coffee Table - Final Piece (3 of 6)

To create a coffee table for my living room I started just a cube.










I then changed the size of the cube to 120m on the X axis, 30m on the Y axis and 70m on the Z axis.  Now the shape is more of a cuboid

I then selected the Face Tool and selected the front and the back face of the cuboid.










Then with the faces still selected I used the Extrude Inner tool and put the offset to 2.5m









I then got rid of the selected faces by pressing delete on the keyboard and it got rid of it and leaves a gap in the middle.

In these 2 pictures where the back face was you can see where you extruded in, so to change this and make it not visible I used the Bridge Tool and drag it from corner to corner and it patches it up.






In then used the Bevel Tool to get that look on the table but I had to select the edges first and to do that I had to use the Loop Selection tool for the edges on the front and back then used Live Selection for the side edges.  Then changed Bevel settings to Inner offset to 0.4m added 2 subdivisions and changed the type from Linear to Convex.







Then on the base I selected the face and extruded it in and changed the offset to 4m.












Then with the face still selected I extruded it and changed the offset to 5m so that it looks like it has a little stand.






Finally this is what my coffee table looked like when I had completed it I added a wood material to it, so it looked like a piece of furniture you would buy for your house.