Cup - Final Piece (4 of 6)

I created a cup to put on the coffee table and I got a image off google and then I went into front view and then pressed shift & V and then pressed back and imported the image.  I used a Bezier Spline add I went around half of the cup and then added a Lathe Nurb and dragged the bezier spline into the lathe nurb and it then makes it whole.








This is what it should look like after you have used the Lathe Nurb.  Because it was a whole object to get rid of the middle so there was space for where the coffee would go I had to delete the cap and then use Close Polygon Hole and then Extrude Inner.









Then to do the handle, instead of using a bezier spline I used a Free Hand Spline and then used a Sweep Nurb.

This is how the handle looks once you have put in the Sweep Nurb but at first the handle was inside the cup so I had to use the knife tool to get rid of it.

I added a cyan looking colour to the cup so it does't look plain.  Also I added a design onto it, I did this by creating it on Photoshop and then importing it onto CInema4D and placing it onto the cup.

So that the cup wasn't empty I added an Oil Tank and then just scaled it down a bit so that it fit in the cup and then changed the colour of it so that it looks like there is tea in the cup.

This is how it look when I had finished, I added a floor with a radial material and I added a 3 Point Light Stage.